How can I start using the Wave 1 Hot Flash Mode?

To start using Hot Flash Mode, tap Modes from the main screen of the app. Tap on Hot Flash Mode (in the Cooling section) to set it as your default for all future cooling sessions, until or unless you decide to change it. 

output-onlinejpgtools__1_.jpg  output-onlinejpgtools.jpg

After selecting Hot Flash Mode, start cooling either by:

  1. Clicking the blue side of the light bar on your Wave; or
  2. Tapping the X to exit out of the Modes menu, and then tapping the blue/ - side of the light bar on the main screen of the app. (You can also drag the blue dot to your desired temperature level to start cooling.)

If you don't see Hot Flash Mode in your Modes menu, you may need to manually update your app. Find the Embr Wave app in the App Store (iOS devices) or Play Store (Android devices) and tap UPDATE. Hot Flash Mode was released with app version 1.5.1 in April 2020.

Can’t find your answer in our support center? Contact us directly.