embr-labs logo
embr-labs logo

All articles

Video: How to reset your Wave 1 [2 minutes]Updated a year ago

Having problems with your Wave, and none of the troubleshooting steps seem to work? One thing you can try is doing a factory reset of your Wave. This 2-minute video shows you how.

(Note: This video shows an older version of the app. While the app looks slightly different now, the steps are the same!)

You can follow along with the instructions in the video, or read them here:

  1. Charge your Wave for 2-3 hours before proceeding. When you're ready to begin, make sure your Wave is unplugged and turned off (no lights in the light bar).
  2. Press and hold the center of the light bar for about 4-5 seconds. Let go when the green pairing light pattern appears.
  3. Press and hold the right (+)/warming side of the light bar for 4 seconds and then release. The light bar will briefly flash white and then turn purple, indicating that it's in reset mode.
  4. In your phone's Settings, find any instances of your Wave on your Bluetooth list and tap Forget this device.
  5. Switch your Bluetooth off and then back on a few times (in Settings and not in the Control Center).
  6. Open up the Embr Wave app. The latest firmware update will start downloading automatically within 10-20 seconds. The light bar on your device will briefly flash blue and then turn yellow while the update is in progress.
  7. Once the update is complete, tap the gear ⚙ icon to enter Settings.
  8. Tap Pair New Device (below Temp Mode toward the bottom of the screen) and follow the prompts on the screen to finish the pairing process. Make sure you see the green light pattern before tapping Confirm.

    TIP: If you’re having trouble getting the green light pattern to appear, you can try pressing and holding both sides of the light bar with your thumbs for 4-5 seconds. Let go as soon as the green light pattern starts and then tap Confirm.

Was this article helpful?